Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

LAN & WAN Basics

Closing Thoughts

The photo of my entire current setup (Figure 14) isn't that pretty to look at, but it gets the job done with room to spare in 2 ft. X 2 ft. of wall space. I ended up rearranging the coax panel boxes when I added the equipment shelf, which was no problem due to my releasable cable tie system (I just tucked the slack cable up between the floor joists).

The whole thing

Figure 14: The whole thing
(click image to enlarge)

This view also shows the two coaxes from my satellite dish coming in from the top left of the photo, crossing over, and connecting directly to the coax panel, which then patches it to the outlet box upstairs in the living room where a DirecTV Tivo is located. The other patch cable takes the RF output from the Tivo over to the TV in my wife's studio. I set her up with a Terk Leapfrog LF-IRX Remote Control Extender that allows her to command the "family" PVR. Relatively low-tech, yes, but free of DRM and streaming hassles.

I also added an inexpensive floor-standing shelf next to the panel, which holds the APC UPS, usually an Infrant NAS, and an assortment of products waiting test or to be returned to their manufacturers. I decided against putting in a 19 inch rack because, as you can see, my equipment doesn't require one, they're a relatively expensive way to hold things and I had plenty of other ways to spend that money in a new home!

I'm pretty happy with how things turned out and think that paying to have the cabling run, but doing the termination yourself is a great way to put some "sweat equity" into a home networking installation without having to pay too much sweat!

But enough about me, how about you? If you'd like to share your story on how you approached the installation of a whole-house network, just drop me a line. A few pix and a short description of what went well, what didn't and lessons learned are all that I need to create a short article that others can benefit from. You know you want to, sooo...just do it now!

More Basics

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I recently had to login to my router because we had lost power and normally after doing that I have to go in and disable port forwarding for my intern...
I have an Asus RT-68U and while it covers the house great, it's not so great out toward the back yard. The house has aluminum siding (which I suspect ...
Not sure whats going on. I'm trying to enable SSH but the option is missing from the Administration > System page. I've looked all over the forums and...
I have been trying to minimize interference with other neighbouring 5Ghz networks but does anyone know why the choices are limited to 36-48 and 149-16...
I'm playing around with iperf3 to test the speed between my laptop and the R7800 (running in AP mode) and between the R7800 and the firewall (OPNsense...

Don't Miss These

  • 1
  • 2
  • 3