Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

LAN & WAN Features

The Test - Simultaneous Up and Downlink

So I set out to see if either DD-WRT or Tomato would smooth out the GL's high throughput variation and raise the maximum number of simultaneous sessions that it would support. My first step was to load up the current firmware release (4.30.12) and rerun my standard set of router tests.

Figure 1 shows that the high throughput variation that I saw with Linksys version 4.30.2 firmware is still there. (You can see the orignal IxChariot plot here.)

Linksys WRT54GL simultaneous up / down throughput with Linksys 4.30.12 firmware
Click to enlarge image

Figure 2: Linksys WRT54GL simultaneous up / down throughput with Linksys 4.30.12 firmware

The results with DD-WRT v23sp2 loaded are shown in Figure 3. It looks like DD-WRT allows uplink and downlink throughput to not battle each other as it does in the factory firmware. But when both up and downlink traffic are simultaneously high, uplink gets most of the bandwidth.

Note that I checked that the DD-WRT QoS features were disabled and also tried the SPI firewall disable. Neither changed the imbalance between up and downlink throughput.

Linksys WRT54GL simultaneous up / down throughput with DD-WRT v23sp2
Click to enlarge image

Figure 3: Linksys WRT54GL simultaneous up / down throughput with DD-WRT v23sp2

Figure 4 shows the same simultaneous up and downlink test run with Tomato 1.19 loaded. While the behavior is different than that of the factory firmware, I don't think that you can say that it's better.

Linksys WRT54GL simultaneous up / down throughput with Tomato 1.19
Click to enlarge image

Figure 4: Linksys WRT54GL simultaneous up / down throughput with Tomato 1.19

More LAN & WAN

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi there,I am planning to use a spare unused ac68u as a switch. Could you guys please recommend the best way. Set it as an AP with disabled WiFi, or a...
I purchased a used RT-AC66U off ebay to use as an access point. It did not come with a power supply and I was good with that because I had an old one ...
Available by firmware update check.Not posted to the website yet.
So I upgraded(?) from my not so trusty RT-N66U to a shiny new RT-AC86U in the hope of getting a little more wi-fi range. Unfortunately I occasionally ...
I was trying to figure out if I could install the Amateur Radio AMPRNET rip44d on a ASUS RT-AC-5300. I would be following the guidelines for OpenWRT: ...

Don't Miss These

  • 1
  • 2
  • 3