Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

LAN & WAN Reviews

PowerLine AV2 2000 Gigabit Network Extender Kit
At a glance
ProductD-Link PowerLine AV2 2000 Gigabit Network Extender Kit (DHP-701AV)   [Website]
SummaryFirst HomePlug AV2-MIMO adapter using Broadcom's BCM60500 chipset
Pros• Can provide 450+ Mbps of total throughput with multiple traffic sources
• Reacts quickly to line noise changes
Cons• Huge up/downlink imbalance in simultaneous throughput test.


There has been some excitement about D-Link's DHP-701AV "2000 Mbps" HomePlug AV2 adapter due to the largest number yet on a powerline product. But it's yet another case of over-zealous marketing to too-gullible consumers.

As the good ol' HomePlug AV2 profile chart trotted out in previous reviews shows, the top AV2 profile is only 1.5 Gbps.

HomePlug AV2 Profiles

HomePlug AV2 Profiles

D-Link is likely using the same, uh, creative math given as explanation for the 1000 Mbps "speed" claimed for ZyXEL's PLA5206 and just multiplied by two, since the DHP-701AV is a MIMO adapter. Here is the explanation again:

  • Broadcom HPAV2 SISO device can use a bandwidth of up to 84.3 MHz (from ~1.8 MHz up to ~86.1 MHz).
  • In this bandwidth, a total of 3455 OFDM carriers are employed with a minimum symbol time of 40.96 us
  • The maximum bit allocation per carrier is 12
  • The maximum PHY rate is obtained as follows: 3455 carriers x 12 bits/carrier ÷ 40.96us = 1012.2 Mbps

You'll see shortly that performance is nowhere near 1000 Mbps, let alone 2000 Mbps.

The DHP-701AV is fairly large as current-design powerline adapters go. The photo below provides an idea of its 3.89" x 2.86" x 1.34" profile and shows it won't block the adjacent outlet in a standard U.S. duplex. The serial number label specs a 100 - 240 VAC 50/60 Hz operating range. Note the photo shows the individual adapters are labeled DHP-700AV.

D-Link DHP-701AV plugged in

D-Link DHP-701AV plugged in

The callout diagram below shows the adapter supports tri-color HomePlug link quality indication. The single Gigabit Ethernet port is centered on the bottom of the adapter, with the Reset / Encryption button sitting to its left.

D-Link DHP-701AV callouts

D-Link DHP-701AV callouts

The User Guide says the adapter goes into power-saving mode after 5 minutes of Ethernet inactivity and powers up again when activity resumes. I verified this by the following procedure, which ran without a hitch.

  1. Plugged in two adapters, let them link up and started a long ping from the HomePlug connected machine to another machine on my Ethernet LAN.
  2. Unplugged the cable connecting one adapter to my LAN switch. Verified that ping showed no response.
  3. Waited until the Ethernet unplugged DHP-701AV entered power-save.
  4. Plugged Ethernet back in and verified that adapter powered up and ping returns resumed within a few seconds.


The DHP-701AV kit is the first appearance of the second HomePlug AV2 device Broadcom announced over a year ago. The inside photo below clearly shows the BCM60500, which is coupled to the sheet-metal thermal spreader in the top cover via the thermal pad stuck to the spreader.

D-Link DHP-701AV inside

D-Link DHP-701AV inside

The plastic case has only a few measly vent holes on the back of its case. The case got moderately warm to the touch.

More LAN & WAN

Wi-Fi System Tools
Check out the new Wi-Fi System Charts, Ranker and Finder!

Featured Sponsors

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

setup - two converted TM-1900's to 68P running latest build of Merlin FW 384.3. One setup as the main router, the other in repeater mode. The repeater...
I want to try out AiMesh on my RT-AC68U while Merlin decides if he wants to incorporate it in his future build.Can I flash the ASUS OE Firmware over M...
My summary scenarios after two days of many code loads, factory resets and/or initialises, and configuring.a). Two Epson ink jet printers Artisan 837 ...
I just flashed an Asus RT-AC87R with Merlin (380.69.2) and all seems fine. Looks like really nice firmware. Per device, DNS setting is a really welcom...
Question: does dropbear accept ssh key pairs with a passphrase? I've copied a public key into the ssh settings (which I normally use, I just generated...

Don't Miss These

  • 1
  • 2
  • 3