Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS How To

Introduction

So you now have followed Part 1 of this 'How To' and have completed the hardware part of the project. In this part, we're going to install the open source software that will get your modified 'box running as a SAMBA fileserver. We'll also get a complete LAMP-based webserver up and running so that we can install the TorrentFlux client that you'll be able to use to manage all your BitTorrent downloads.

First, you can now put the top back on your modified Xbox and tuck it away in a cupboard and forget about it. Everything we do from now on will be via SSH. Now it's time to do a bit of reading. If you're not familiar with Linux partitioning, formatting and mounting, first take a look at this entire document. To format and mount our new disk you will need to type in the following when logged in as root:

fdisk /dev/hdb
n (new partition)
p (primary partition)
1 (partition 1)
enter ( to select the default first cylinder of 1)
enter ( to create the partition using the entire disk)
w (to write the new partitions to disk)
q ( to quit )

now format it with:
mkfs -t ext2 -j -m 1 /dev/hdb1

Then create a directory in which you will mount the disk:
mkdir /samba_share (or whatever you want to call it)

and then make it readable and writable to everyone:
chmod 777 /samba_share

Now we want to automatically mount the drive every time the Xbox boots. Edit your /etc/fstab file using vim, and add the following line at the bottom:
/dev/hdb1 /samba_share ext3 defaults 2 1

then exit vim and then mount it:
mount /samba share

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Not sure if the term is right but the HOOTOO can connect to a wifi network (think hotel with www page signon screen) then on a seperate IP range (usua...
Here is my network configuration in the company I work for:Me (192.168.90.X) -- (lan)RT-68U(wan) -- Printer (192.168.0.X) -- (lan)ROUTER(wan) -- INTER...
Hi all,I cannot seem to open up the above ports on my brand new Nighthawk X4S / 7800.Several other ports opened up without a problem, but not these, w...
Although my ISP modem is set to bridge mode and I use PPPoE to connect to the ISP on an Asus router with Merlin f/w, just recently the WAN IP is now a...
After updating the internet status show as disconnected but it is not disconnected.On startup, it will momentarily show the correct information then s...

Don't Miss These

  • 1
  • 2
  • 3