Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Construction Details

As you'll see later, the 323's performance is among the highest performing products in our NAS charts. A view inside the 323 reveals that Marvell technology is powering the 323. Figure 3 is a photo of the 323's chassis, where you can see the drive backplane plugged into the main circuit board.

DNS-323's chassis
Click to enlarge image

Figure 3: DNS-323's chassis

Figure 4 is a close-up of the main board, where the components are clearly shown. The processor is a Marvell 88F5181, which is based on Marvell’s proprietary Feroceon ARM CPU architecture. The SATA drive interface comes courtesy of a Marvell 88X7042 is a PCIe to Serial ATA Controller chip, while a Marvell 88E1111 "Alaska" single-port gigabit Ethernet tranceiver handles the Ethernet port duties. The Marvell CPU must also handle the single USB 2.0 port since there don't seem to be other chips present for that function.

DNS-323 main board
Click to enlarge image

Figure 4: DNS-323 main board

Like most other consumer NASes, the 323 runs Linux. So if you want to try some hacking, visit the 323's GPL download page to get the sources you'll need.

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi There,Update 2020/08/06386 rc2-3 firmware is in this linkhttps://drive.google.com/drive/folders/154vHdrYh_rGP_qFooHgAkzXSJchge7Ue?usp=sharingChange...
Is it possible to have the following setupAC5300 as primary router / wireless AP running Merlin and then AC88U as a AiMesh node also running Merlin?[Y...
I have an AiMesh setup with a AC88U as a base and 2 AC68U as Nodes which are cabled to the base. One AC68U is in a room with a fixed device ( a Ethern...
I was doing some research and was seeing a lot about issues with the 2.4ghz band not working after a while or having very short range (or poor perform...
I am looking for a couple of hardwired aimesh nodes around the house but it would be nice if they are small, can be mounted on the wall and are somewh...

Don't Miss These

  • 1
  • 2
  • 3