Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Wi-Fi Router Charts

Click for Wi-Fi Router Charts

Mesh System Charts

Click for Wi-Fi Mesh System Charts

How Will LTE-U / LAA Play Fair?

So an LTE-U / LAA network will behave no worse than a neighboring 5 GHz network? Actually, in many cases LTE-U or LAA may be friendlier because it is designed to be, using three coexistence mechanisms illustrated in the flow diagram below.

LTE-U coexistence algorithm flow chart

LTE-U coexistence algorithm flow chart
(from Qualcomm Harmonious Coexistence with Wi-Fi whitepaper)
  1. Channel selection - Unlicensed LTE will always try to find an unused channel first. Channel utilization is also monitored on an on-going basis and the channel will be changed if a better channel (lower use) is found.
  2. Adaptive channel use - Unlicensed LTE trasmission on / off duty cycle is monitored and adjusted to ensure fair sharing. CSAT is used for this in LTE-U; LBT is used for LAA.
  3. Secondary Carrier Disable - If LTE traffic demand is low, the 5 GHz carrier can be shut off entirely, removing all unlicensed LTE sharing overhead.

In addition, LTE-U / LAA uses one 20 MHz channel at a time vs. 802.11ac Wi-Fi networks that hog four channels. It can aggregate up to four channels, in which case it will act more like 802.11ac. LTE-U is also downlink only since that's where the bulk of bandwidth demand is. 5 GHz uplink support is in the mix for later versions of LAA.

Compared to your Wi-Fi neighbors, who can park on whatever channel they want and battle for bandwidth with no Wi-Fi fair sharing mechanisms, unlicensed LTE seems like a neighbor you'd rather have.

By the way, LTE-U and LAA do not use DFS channels, due to the additional requirements imposed on devices using these channels. (See SmallNetBuilder's Wi-Fi Dynamic Frequency Selection (DFS) FAQ for more info.) So if you want to avoid potential LTE-U interference entirely, you could stick to using only DFS channels. But that brings its own set of challenges, so may not be a practical solution for many.

What Will LTE-U Look Like?

So an obnoxious neighbor who hogs the entire 5 GHz band all the time with streaming video moving in next door and there is nothing you can do about it. Not exactly. Before you panic and start looking for 40 acre parcels in the desert, there are few things to keep in mind.

First, remember this is 5 GHz we're talking about. While Qualcomm may insist LTE-U provides coverage superior to Wi-Fi, we're not talking miracles. So lighting up an area with LTE-U requires installing or upgrading lots of small cells, each of which would have range similar to the 5 GHz Wi-Fi router or AP you already have.

Although T-Mobile hasn't provided specifics on where LTE-U will be rolled out, it's more likely to be in high-density use areas like airports, stadiums, convention centers or shopping malls. Or it could be as localized as partnering with Starbucks, McDonalds or other retailers who offer free Wi-Fi. Rolling out LTE-U in relatively low density areas like residential neighborhoods is much more unlikely as a first priority.

A possible scenario for residential area LTE-U deployment would be via set top boxes. AT&T and Verizon are in the best position to do this since they have both mobile network and internet service arms. Just as Comcast boxes act as XFINITY hotspots, U-verse or Fios boxes could be upgraded to include an LTE-U eNB. Another way to bring LTE-U to residential users would be for carriers to offer new micro or femtocells with LTE-U / LAA built in. Again, no plans have been announced, so this is just speculation.

Of course, user devices will also need to support LTE-U / LAA, but Qualcomm has planned ahead. LTE-U support is in its Snapdragon 820 X12 modem and LAA support was added in the Snapdragon 835 X16. So LTE-U could be enabled in phones with either of these devices, but that is all up to the carrier.

The Snapdragon 820 is used in the Samsung Galaxy S7 and Galaxy S7 Edge, Xiaomi Mi5, LG G5, HTC 10, LeEco LeMax Pro and LeMax 2 and Sony Xperia X Performance. Google's Pixel and Pixel XL use the more recent Shapdragon 821, which also includes the X12 modem with LTE-U support.

Handsets using the Snapdragon 835 that supports LAA and LTE-U are just appearing and include most notably the Samsung Galaxy S8. Sony Xpreia XZ Premium, Microsoft Surface phone and Xiaomi Mi 6 also use the Snapdragon 835.

Conspicuously absent from the above lists are any iPhones. However, iFixit's iPhone 7 and iPhone 7 Plus teardowns show both use Qualcomm's Snapdragon X12 modem, which means they also could support LTE-U.

Update 4/2/17: A helpful reader tipped us to T-Mobile's March 29 announcement that the Samsung Galaxy S8 and S8+ will be the first devices to run LTE-U on their network.

Coexistence Test Plan

With 5 GHz Wi-Fi's future depending on the mobile industry's promise to play fairly, our final stop in this LTE-U tour is a closer look at exactly the Wi-Fi Alliance's LTE-U / Wi-Fi Coexistence Test Plan contains. That link lets you download the entire test plan for free; you just need to give up some contact info.

The Alliance's Unlicensed Spectrum page contains links to Coexistence Workshop presentations if you want more background on how the sausage got made. The final Sept 2016 Workshop held the day before the plan was release is an interesting read. There's also a pilot study report of a multi-vendor Wi-Fi performance study the Alliance ran to get a baseline on how multiple Wi-Fi networks compete for bandwidth. The results from this study were used to set pass / fail limits for the Coexistence Test Plan. To save you a read, the report concluded:

"Simultaneous operation of two Wi-Fi networks shows that both networks share the medium extremely well with a mean [bandwidth] sharing difference of better than 2.5%. The aggregated throughput of both networks is very similar to the throughput of a Standalone network indicating that the sharing is very efficient."

Basically, this says Wi-Fi networks are good at sharing bandwidth.

As noted earlier, use of the Coexistence Test Plan is not mandatory. But if the plan is used, all tests are mandatory. Quoting from the Test Plan Scope and Purpose:

"Furthermore, the tests described in this document are intended to represent a complete set, and all tests are considered equally important and mandatory to demonstrate reliable coexistence. Any divergence from this document, or any incomplete demonstration of coexistence, is not deemed to be reliable."

Key takeaways from the test plan:

  • A hybrid cabled / OTA testbed is recommended.

Wi-Fi Alliance LTE-U Coexistence Test Plan Testbed

Wi-Fi Alliance LTE-U Coexistence Test Plan Testbed
  • The test plan has five major sections that verify the LTE-U device under test:
    • Selects a vacant or least used Wi-Fi channel
    • Allows Wi-Fi devices to associate when LTE-U is in operation
    • Adapts its airtime use as Wi-Fi channel load changes
    • Has a limited impact on latency-sensitive Wi-Fi traffic
    • Equally shares Wi-Fi traffic bandwidth
  • Most of the test plan concentrates on tests with Wi-Fi networks operating in 802.11ac, 20 MHz bandwidth mode. The only tests operating with 40 MHz or 80 MHz Wi-Fi links are one test to check that the LTE-U equipment chooses a vacant channel and two tests that check that it uses least-used channels.
  • The approved test bed Wi-Fi APs are business APs from HP / Aruba (APIN0204) and Ruckus Wireless (R710). The only approved consumer Wi-Fi AP is an ASUS RT-N66U (N900 class), used for some of the channel use checks described above.
  • Tests are run with Wi-Fi link levels of -50 dBm, -67 dBm and -82 dBm. Not all tests are run at all three levels. In all cases, the LTE-U eNb transmit power is set at maximum.

While we should appreciate all the work and excess stomach acid involved in creating this plan, it clearly is not one focused on LTE-U's impact on consumer Wi-Fi networks going forward. Most of those networks either operate in 80 MHz 802.11ac in 5 GHz, or will after trading up to 802.11ac gear. The only thing the Coexistence Test Plan verifies for consumer 11ac networks is that an LTE-U device will select a vacant or least-used channel.

Closing Thoughts

Call me naive, but I'm less cynical about LTE-U / LAA than when I started to write this article. True, Qualcomm has a lot at stake and I've referenced a lot of their material. But I think all the pushback from concerned Wi-Fi citizens (and product makers) has brought unlicensed LTE to a better place than where it started. Fair sharing with Wi-Fi appears to be baked into the technology cake and there are is a process in place, albeit optional for LTE-U and by no means perfect, to verify that unlicensed LTE will be a good Wi-Fi neighbor.

But the Coexistence Test is clearly not focused on verifying that consumer Wi-Fi gear won't be negatively affected. And given the wide berth 802.11 specs give chip and end-device makers to, uh, innovate, it's safe to say we won't really know LTE-U's impace on home networks until it moves in next door. What will happen when every network it sees is using 80 MHz bandwidth? And how about when it sees APs advertising non-standard 1024 QAM link rates or operating with 160 MHz or 80+80 MHz bandwidth? We'll just have to wait and see.

For now, though, I think most of our home Wi-Fi networks will be safe from ill effects from LTE-U or LAA for the near future. But if AT&T or Verizon decide to add LTE-U to their U-verse or Fios boxes, then we'll really see how well unlicensed LTE plays with Wi-Fi.

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Don't Miss These

  • 1
  • 2