Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless News

I've been offline for a few days, but will be back to normal next week. In the meantime, it looks like there has been a bit of news in WiFi land.

Seems like the Wi-Fi Alliance has finally decided to give these two aging wireless security standards some help out the door and on their way to obscurity.

Glenn Fleishman did the legwork to confirm with the Alliance that TKIP and WEP will be phased out in new Wi-Fi Certified devices starting in January 2011 through January 2014.

According to Glenn's report, WPA-TKIP support in access points and wireless routers will be the first to go in 2011, then for clients (STAs) in 2012. WEP supports in APs / wireless routers stops in 2013, followed by no more mixed WPA TKIP / AES mode in 2014.

You'd think that something this important would merit a press release, or even a heads up from the Wi-Fi Alliance. But neither was forthcoming.

Good thing there are guys like Glenn around to keep an eye on things! Read the full story over on WNN.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi all,I have overgrown my number of devices that I can connect to my AC68U running Merlin's 384.13. So going to buy a GS305E switch. In terms of netw...
Hi, Any one can help to take a look the log file. I just bought it 2 - 3 days ago. It was running ok until I decided power cycle it. After the router ...
What is the command in the CLI to set spanning tree bridge priority? I'm hoping that STP is not just limited to ON or OFF.
Hi all,Hoping someone can help me out as I'm usually quite clued up with internet setups but I've moved house to a total not-spot. 1.3mb DSL, no fiber...
I'm using firmware 384.13QOS mode is set to bandwidth limitation.I have one station that has "Steam" on it. To avoid it taking the entire bandwidth I ...

Don't Miss These

  • 1
  • 2
  • 3