Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Wireless Performance

No Link Quality or Strength readings were available
Testing was done with a Linksys WPC54G card in AdHoc mode in a Dell Inspiron 4100 laptop running WinXP Home

Rather than lug around the WET connected to my laptop, I plugged one set to AdHoc mode into my LAN's switch and used a Linksys WPC54G card also set to AdHoc mode to do the testing. As both the table above and Chariot plot below show, performance was surprisingly poor.

Linksys WET54G: Four-location throughput test results

Figure 5: Four-location throughput test results
(click on the image for a full-sized view)

Note that his pattern is similar, but worse than, the results I obtained when I tested the Linksys WRT54G and WPC54G (Figure 6).

Linksys WRT54G - Four condition throughput test

Figure 6: Four Condition Throughput test - WRT54G and WPC54G
(click on the image for a full-sized view)

To test whether the WPC54G was the problem, I tried a few tests with a Belkin F5D7010 54g CardBus card and also tried forcing the Linksys card to 24, 11, and 5.5Mbps transmit rates while testing at my Condition 3 location. In each case, however, I obtained similar results, so I have to conclude that the WET's radio is the cause of the poor performance.

I also tried a few close-range (my test Condition 1) tests with 802.11b clients.

Linksys WET54G: Condition 1 throughput - NETGEAR WAB501 and Linksys WPC11v3

Figure 7: Condition 1 throughput - NETGEAR WAB501 and Linksys WPC11v3
(click on the image for a full-sized view)

Figure 7 shows that the Atheros-based NETGEAR WAB501 performed nicely, but that the Intersil-based Linksys WPC11v3 had some problems with maintaining a connection. I retried the Linksys card about three times, and each time experienced connection drops before my one-minute run had finished. The NETGEAR card, however, was solid as a rock, even during a 5 minute extended test.

I also did quick tests at my Condition 3 location for both cards and found they maintained the throughput you see above. I guess the WET54G's Intersil-based radio is a better performer for 11b CCK-based operation vs. 11g's OFDM.

802.11g Wireless Performance Test Results

Test Conditions

- WEP encryption: DISABLED
- Tx Rate: Automatic
- Power Save: Disabled
- Test Partner: Linksys WPC54G in AdHoc mode

Firmware/Driver Versions

AP f/w:
1.05 April 18,2003 WET54G
Wireless client driver:
WinXP (WPC54G)
Wireless client f/w:
No Info

Test Description Signal Strength (%) Transfer Rate (Mbps) Response Time (msec) UDP stream
Throughput (kbps) Lost data (%)
Client to AP - Condition 1 0 21.1
[No WEP]
[w/ WEP]
1 (avg)
2 (max)
499 0
Client to AP - Condition 2 0 21.6 1 (avg)
2 (max)
335 7
Client to AP - Condition 3 0 0.25 0 (avg)
0 (max)
0 0
Client to AP - Condition 4 0 1.4 495 (avg)
4807 (max)
133 12
See details of how we test.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I think rmerlin deserves some financial thanks, so I sent him a couple bucks.Post below when you support rmerlin with a donation! Thank you, rmerlin f...
Update 2020/12/31 ( 386 rc2-10 - Google Drive This version includesZenWiFi XT8, XD4, CT8GT series: GT-AX1...
No stats on webui and getting a failed debug info for log level 7. Any idea?
Hi EveryoneI often dip in and out of SNB to research and solve my own problems but I am really struggling with this one.I noticed certain settings tha...
Morning,Does anyone have good general settings for flex qos, that essentially keep a low stable ping in games, whilst allowing everything else on the ...

Don't Miss These

  • 1
  • 2
  • 3