Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Setup and Admin

The 2870W's schizophrenic nature really becomes apparent when setting up the product. The setup confused me so much that I called SMC to get an explanation, which I'll now pass on.

Admin is supported via both a web-based interface and a Windows (98SE, Me, 2000, XP) application. The application finds the 2870W (which ships with a default IP address of, and allows you to configure some of its settings.

SMC2870W - Setup application screen

Figure 2: Setup application

It also - as Figure 2 shows - allows you to change the 2870W from its default Bridge mode to Access Point mode. This actually involves a firmware reload and device reboot, which the application takes care of using embedded firmware files. Unfortunately, this personality change resets the IP address to the default, which I found annoying.

If you run a non-Windows OS, or simply would rather use the web-based interface, you'll need to set your computer to an address in the 192.168.2.X subnet, then connect to the 2870W's default IP address.

SMC2870W - Bridge mode Basic Settings, Web interface

Figure 3: Bridge mode Basic Settings, Web interface
(click on the image for a full-sized view)

Figure 3 shows the "Basic" settings page for the Bridge mode. Most of these are self-explanatory, but I think SMC could have cleaned things up a bit - get rid of the "000000000000" BSSID setting, gray out the channel setting in Infrastructure mode, etc.

If you want to switch modes via the Web interface, you'll need the appropriate firmware file on a local computer and then upload them from the Admin Settings page.

By the way, SMC explained that the reason for this firmware swap was due to limited memory in the 2870W. I guess they saved some money that way, but it remains to be seen whether customers will be ok with the trade-off.

The web-based interface is very responsive if you're using Internet Explorer. The going is very slow, however, if you use Mozilla or a recent version of Netscape based on the Mozilla engine.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hello, I want to preface that I've come to this forum for troubleshooting in the past and I've usually found the answers I was looking for with a simp...
Morning,Does anyone have good general settings for flex qos, that essentially keep a low stable ping in games, whilst allowing everything else on the ...
Switching from old RT-AC68U to RT-AC86U found many differences.First, I enabled DoT, router mode in the settings, and enabled "Use local caching DNS s...
Looking for adviceHouse is wired as this. FIOS ONT in garage, wire down to the basement, connected to Ax88u WAN. 4 AC86u routers are connected to LAN ...
Due to the lack of IPv4 public IP address, we hope to use IPv6 to connect OpenVPN to access the intranet. The actual test is available. We only need t...

Don't Miss These

  • 1
  • 2
  • 3