Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

Linksys Wireless-G Range Expander

Linksys Wireless-G Range Expander
Summary WDS-based wireless repeater. Designed for use with Linksys WAP54G, WRT54G & WRT54GS, but can be used with other WDS-based products if you're adventurous
Update None
Pros • Auto-setup works well with targeted products
Cons • Poor and highly variable throughput vs. range
• Limited troubleshooting tools
• Inconsistent performance

The addition of WDS-based (Wireless Distribution System) bridging and repeating features to consumer wireless products has been a mixed bag for consumers and networking product producers alike. On one hand, it has enabled some purchasers to extend their wireless network's range or join wired LANs in separate buildings at a very reasonable cost. But the flip side is that manufacturers' support lines have been buzzing by bewildered consumers trying to figure out how to get the darned feature to work.

It hasn't helped either that the user interfaces for WDS features haven't used consistent nomenclature or even be properly identified as WDS-based by some manufacturers bent on trying to differentiate their products. And don't even get me started the poorly written user documentation! The whole mess seems to cry out for a solution.

Buffalo Technology's has tried an approach of bundling a wireless router and repeater as a pre-configured kit. But with its WRE54G Wireless-G Range Expander, Linksys has taken another road. They have abandonded the signal amplifier route taken with the wildly popular, but now discontinued, WSB24 [reviewed here] and instead opted to take a WDS repeater approach that will minimize their certification activities with the FCC. I found that Linksys' intentions were noble, but that its goal of an auto-configuring wireless repeater has been only partially met.

Tip! Tip: See our Setting up WDS Bridging / Repeating HowTo for help in sorting the whole WDS mess out.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

AC86U (but I also have the same problem with AC87U). Using USB drive attached to router to store files. After I copy files to router via FTP, everythi...
When I have client 1-5 all connected to 5 different VPN servers with the default settings on a fresh install, what exactly is the behavior? For me it ...
I noticed that under system logs there's a field for an IP address.Is there any way to set the IP address to say, a computer on LAN or a connected USB...
I was hoping someone here might have some experience to help me. I cannot rename attached devices on the R6700 router. It has the latest firmware and ...
Hii'm not able to use external hard disk formatted to ext4 or xfs however ntfs is working fine. since i dont have any windows machine, didnt see a poi...

Don't Miss These

  • 1
  • 2
  • 3