Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

NOTE: This product has been discontinued.

Netgear RangeMax 240 Wireless Router
Summary 802.11b/g enhanced-wireless router based on 3rd gen Airgo chipset. Reaches peak aggregate throughput over 100Mbps.
Update 3/13/2006 - Added information on original RangeMax and 108 Mbps client interoperability
2/2/2006 - Added note to clarify Table 1 and 2
1/26/2006 - Revised WQS calculation method and posted new charts
Pros • Can achieve > 100Mbps aggregate throughput
• 100Mbps wire-speed routing
Cons • Non-MIMO clients take big throughput hit in mixed WLANs
• Not a good wireless neighbor
• Uncompetitive routing features
• Expensive

NETGEAR WPNT834 RangeMax 240 Wireless Router

Airgo Networks rocked the MIMO world last fall with the announcement of its third generation "True MIMO" chipset that boasts a top raw speed of 240Mbps. The new speed is achieved using Airgo's Adaptive Channel Expansion technology (ACE) that the company says uses a "neighbor friendly" 40 MHz channel.

Netgear wasted no time in getting its WPNT834 RangeMax 240 (RM240) router and WPNT511 CardBus card on store shelves, but also managed to save a copy of each to send to the SmallNetBuilder labs. We found that the product's maximum speed was indeed impressive, topping 100Mbps under the right conditions. But we also saw behavior that does not bode well for use with mixed WLANs and, contrary to Airgo's claims, that won't be particularly welcome by wireless neighbors.

Basic Features

The RM240 comes in the same-sized white plastic enclosure as its first RangeMax router. But the frosted plastic dome that houses the annoyingly bright blue LEDs on the Gen 1 RangeMax router (that is based on antenna technology from Ruckus Wireless and a chipset from Atheros) has been replaced by a sold silver disk embossed with the Netgear logo. Instead, there are three dipole antennas that sprout from the rear panel of the RM240. All three are movable, but only one is attached via an RP-SMA connector - a combination that seemed to be an odd choice.

The backlit front panel icons are bright enough and include link/activity for the four 10/100 LAN ports and one 10/100 Internet (WAN) port. Power, WLAN activity and Test icons round out the indicators. Connectors on the rear panel include four 10/100 LAN ports, one 10/100 WAN port and a power jack. All ports are auto MDI / MDI-X which means they'll figure out how to connect to whatever you plug into them. There's also a reset-to-factory-defaults switch on the back panel in case you need it.

Ever since wireless products started specifying speeds above 100Mbps, I've been asking manufacturers as to the whereabouts of their gigabit Ethernet ports. Netgear's reply was something along the lines that the RM240 isn't intended to supply its super-speedy bit goodness on an individual port basis. Instead, the pitch is that aggregate 100Mbps+ throughput, i.e. across a number of ports, is what Netgear's intending to supply. More on this later when we walk through the Throughput testing.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

How can i get IKEV2 IPsec server up and running?I can see only IKEV1 under IPsec advancedThanks
Greetings,I am running the official AsusWRT firmware (45717) on AC68U. In my previous setup I was using AiMesh, which was problematic. I have just mov...
I'm trying to set up a SanDisk Cruzer 64GB flash memory device to use as storage for my security cameras. It's attached to the rear USB port on my new...
Hi all i need some help.Dual-wan in fail over mode does not have wan0 and wan1, however if you disable and enable the secondary connection it goes fro...
AC5300latest FW 384.13friends i get too many below type of messages in my log for various Mac ids :Sep 17 20:08:11 WLCEVENTD: eth1: Disassoc Sep 17 20...

Don't Miss These

  • 1
  • 2
  • 3