Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Wireless Performance

I tested the 350 using our wireless test procedures, which use both open-air testing and Azimuth's ACE 400NB Channel Emulator.

Because Linksys has still not released the Draft 2.0 firmware for the single-band WPC300N card, I used a Linksys WPC600N Notebook card, which has Certified firmware. The card was inserted into a Fujitsu P7120 Lifebook (1.2 GHz Intel Pentium M, 504 MB) notebook running WinXP Pro SP2 with all the latest updates. I used the driver with Windows Wireless Zero Config.

The router had 1.03.7 "Draft 2.0" firmware and I left all factory default settings in place, except as noted.

Maximum Throughput

To start, I ran some close range open-air IxChariot tests to look at maximum performance and throughput variation. This also provides baselines to check the Azimuth results against. Testing was done with the router and notebook about 10 feet apart in open air sitting in my lab with no other networks in range.

Figure 8 shows a composite IxChariot plot of uplink, downlink and simultaneous up and downlink tests in the 2.4 GHz band. The test was made with router defaults, which as I noted, properly used the 20 MHz Channel mode. Total simultaneous up/down throughput comes in around 69 Mbps, while running up and downlink separately yielded results of ~ 58 and 65 Mbps respectively.

Up and downlink throughput - 2.4 GHz band, 20 MHz bandwidth
Click to enlarge image

Figure 8: Up and downlink throughput - 2.4 GHz band, 20 MHz bandwidth

The same throughput "dropout" anomaly found in the 600N's throughput is also present in the 350N, which has the effect of lowering average throughput.

Figure 9 shows a composite of test runs with the 40 MHz channel bandwidth mode forced. This improves total simultaneous up and downlink throughput to 95 Mbps. Running up and downlink separately yielded results of 73 and 66 Mbps respectively.

Up and downlink throughput - 40 MHz bandwidth
Click to enlarge image

Figure 9: Up and downlink throughput - 40 MHz bandwidth

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Not sure whats going on. I'm trying to enable SSH but the option is missing from the Administration > System page. I've looked all over the forums and...
Hello.Currently at Traffic Analyzer -> Statistic -> Top 5 the pie chart shows only 5 devices, which is a little misleading (arguably useless) because ...
I have been trying to minimize interference with other neighbouring 5Ghz networks but does anyone know why the choices are limited to 36-48 and 149-16...
I'm playing around with iperf3 to test the speed between my laptop and the R7800 (running in AP mode) and between the R7800 and the firewall (OPNsense...
I recently had to login to my router because we had lost power and normally after doing that I have to go in and disable port forwarding for my intern...

Don't Miss These

  • 1
  • 2
  • 3