Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Mixed STAs

The Vision's performance with a mix of draft 11n and 11g clients was similar to that of previously tested products. I set up my usual test using a second notebook with a Linksys WPC54G V3 11b/g card (Broadcom chipset). Both it and the Fujitsu notebook with F5D8011 V3000 card were associated with the Vision, which was set to its 20 MHz Channel mode, to simulate what should be its proper "out of the box" settings.

I then ran two IxChariot throughput.scr streams, alternating the STA that got on the air first. Figure 18 shows how uplink throughput was shared when the 11n pair started first, while Figure 19 shows the 11g pair starting first.

Mixed 11n, 11g STAs - Uplink, N starts first
Click to enlarge image

Figure 18: Mixed 11n, 11g STAs - Uplink, N starts first

The results follow the same pattern that I've seen with other draft 11n products, i.e. the 11g STA gets knocked down to 11b speeds. In this case the 11g throughput is knocked down to a little under 6 Mbps. The 11n pair also gets a throughput hit, but still manages to average around 33 Mbps when the 11g STA is on the air.

Mixed 11n, 11g STAs - Uplink, G starts first
Click to enlarge image

Figure 19: Mixed 11n, 11g STAs - Uplink, G starts first

Mixed performance in downlink was essentially the same as uplink.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I have been trying to minimize interference with other neighbouring 5Ghz networks but does anyone know why the choices are limited to 36-48 and 149-16...
Hello.Currently at Traffic Analyzer -> Statistic -> Top 5 the pie chart shows only 5 devices, which is a little misleading (arguably useless) because ...
I recently had to login to my router because we had lost power and normally after doing that I have to go in and disable port forwarding for my intern...
I have been trying to get plex installed and to no avail.is there a manual way with telnet to get it installedthe gui gets an unknown error at the bot...
Apologies if this has been asked, but is it possible to import Merlin settings (i.e. AC5300) to a non-Merlin device (i.e. AX11000)?I don't want to go ...

Don't Miss These

  • 1
  • 2
  • 3