Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Throughput vs. Path Loss - Competitive Comparison

Now comes the face-off that you've been waiting for, the only dual-band, dual-radio draft 11n routers available: the 855 vs. Linksys' WRT600N. (I didn't include the Buffalo Nfiniti Dual-band router, since Buffalo is still out of the WLAN market until it comes to some sort of agreement with CSIRO.)

Once again, we have the 3T3R Linksys WPC600N client providing some advantage over the 2T2R Netgear WNDA3100 client used with the 855. For both downlink (Figure 18) and uplink (Figure 19), the WPC600N provides significantly more throughput under high signal levels.

Competitive dual-band comparison - 2.4GHz, 20 MHz, downlink

Figure 18: Competitive dual-band comparison - 2.4GHz, 20 MHz, downlink

The WRT600N / WPC600N combo also stays connected longer running downlink, but not running uplink (Figure 19).

Competitive dual-band comparison - 2.4GHz, 20 MHz, uplink

Figure 19: Competitive dual-band comparison - 2.4GHz, 20 MHz, uplink

The 40 MHz mode provides more throughput boost to the 855 than to the WRT600N, so the throughput gap grows smaller running downlink. The 40 MHz mode uplink comparison shows just about equal performance between the two products.

Competitive dual-band comparison - 5GHz, 20 MHz, downlink

Figure 20: Competitive dual-band comparison - 5 GHz, 20 MHz, downlink

In the 5 GHz band, the 600N once again turns in higher speeds with strong signal levels, both down (Figure 20) and uplink (Figure 21).

Competitive dual-band comparison - 5GHz, 20 MHz, uplink

Figure 21: Competitive dual-band comparison - 5 GHz, 20 MHz, uplink

The 5 GHz, 40 MHz mode once again provides more throughput boost to the 855 than to the WRT600N, so the throughput gap grows smaller running downlink. The 5 GHz, 40 MHz mode uplink comparison, however shows a faster falloff in throughput for the 855.

Use the Wireless Charts to generate other comparisons or dig deeper into these.

Closing Thoughts

The main thing that the DIR-855 has going for it is a solid, fast routing section that is based on Ubicom's impressive IP5170 SoC. That, coupled with a gigabit switch that supports up to 9K jumbo frames and even a gigabit WAN port for those who think that matters.

The wireless, however, is another matter. It's no so much that the two Atheros-based radios aren't good performers, than it is the lack of a client that can hold up its end of the deal. It's bad enough that it took so long for D-Link to come out with its DWA-160 dual-band client. But its current driver makes the 855 (and probably other routers) run at 802.11b speeds at 2.4 GHz and the 2T2R radio is a mismatch with the 855's 3T3R radios, preventing it from reaching competitive top speeds.

The bottom line is that there isn't anything in the 855 that makes it worth the $100 premium over Linksys' WRT600N, which seems to be the simultaneous dual-band draft 11n choice right now. Unless D-Link wants to sit on a pile of inventory, they need to match or beat Linksys' price and get the product on the shelves! As I write this, the word is "end of June", but we'll just have to see what happens.

Check out the slideshow Check out the slideshow

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I wanted to buy RT-AX92U. Since it comes in a AIMesh pack of 2, I was wondering if it is possible to use one unit at my home and another one at my off...
I want to configure my router so all traffic on my network goes through my VPN (PIA). However, I would like a single machine to be excluded from the V...
I'm am trying to update the firmware on my RT-AC68U. It is currently Merlin build 3.0.0.4.374.39. Initially my goal was to try and return it to the la...
Hello everyone I have a home lab that I dib and dabble in. I have recently taking up an interest in PBX and am about to connect to a Trunk. My PBX is ...
Small business. Main network is handled by ISP. We manage our wireless network. We have 3 AC66U. 1 is running in AP Mesh Router mode, 2 are in node mo...

Don't Miss These

  • 1
  • 2
  • 3