Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

Linksys WRT54G2

At a Glance
Product Linksys Wireless-G Broadband Router (WRT54G2)
Summary Repackage of the biggest-selling consumer 802.11b/g wireless router.
Pros • >70 Mbps routing speed
• Uplink QoS
• Internal antennas don't reduce performance
Cons • Routing throughput falloff with >~20 Mbps Internet connection
• 10/100 switch

I have pretty much covered most of what you need to know about Linksys' replacement for its top-selling WRT54G wireless router, the WRT54G2 in the slideshow, product preview and inside story. But for those of you who need an "official" review, here it is.

Hardware Differences

I covered the design details of the G2 in this Inside Story article, but, to recap, the design is based around the Broadcom BCM5354 802.11b/g Router System-on-Chip with BroadRange Technology, 8 MB of RAM and 2 MB of flash.

The circuit design is essentially the same as the most recent WRT54G boards (the WRT54GV8 and WRT54GV82). The key difference in the G2 is that it uses dual internal, fixed position, non-upgradeable antennas sourced from Galtronics vs. the external, movable, upgradeable antennas found on the WRT54G. Figure 1 shows a board photo from the FCC ID docs.

WRT54G2 main board
Click to enlarge image

Figure 1: WRT54G2 main board

Linksys sent along a WPC54G V3.1 notebook card to test with the G2. The card uses a Broadcom BCM4318 AirForce One Single-Chip 802.11g Transceiver with one of the two circuit board antenna lines running through a SiGe SE2528L 2.4 GHz power amplifier.

WPC54G V3.1 board
Click to enlarge image

Figure 2: WPC54G V3.1 board

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi everyone!I'm trying to setup a VLAN om my ac68u to separate my IoT-devices. I've been scanning the forum for clues but I just don't get it working ...
Hi dear,I found today this forum and I subscribed immediately.I have a doubt regarding the firmware.Actually I have an Aimesh net like this:Router AiM...
Hi there, I recently setup a Sophos XG and of course it is not really sufficient, if the is only one user (my ASUS AC88U). So I activated AP mode, whi...
This is FlexQoS, a fork of the original, groundbreaking FreshJR_QOS script written by @FreshJR.FlexQoS provides a fully customizable Adaptive QoS expe...
Tired of having a corrupted USB once in a while after rebooting/powering-off your Asuswrt-Merlin router?Introducing partgrator, a collection of script...

Don't Miss These

  • 1
  • 2
  • 3