Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

NETGEAR WNDR3300

At a Glance
Product NETGEAR RangeMax Dual Band Wireless-N Router (WNDR3300)
Summary Low-cost dual-band two-radio hybrid 802.11b/g / draft 802.11n router
Pros • Street priced below $100
• Internet uplink QoS
• Wireless repeating
Cons • Shorter than average 5 GHz range
• Unstable 2.4 GHz 11n
• 100 Mbps LAN

I have been holding off on reviewing NETGEAR's entry into the sub-$100 dual-band draft 802.11n router race, waiting for Netgear to release its firmware fix for the WNDR3300's low wireless throughput with the 11n radio switched to the 2.4 GHz band [related article].

Well, V1.0.23 was released last week and I retested both the first sample that NETGEAR sent as well as a second sample that was supposed to have lower noise coupling (which was causing the lower throughput). To cut to the chase, I found that the new firmware slightly improved the draft N radio's throughput when set to the 2.4 GHz band. But I also found that, in general, the draft 11n radio set to 2.4 GHz was too unstable for reliable use.

Inside Details

Figure 1 is taken from the FCC ID docs and shows the 3300's board, with its unique two-radio draft 11n / 802.11b/g approach.

The all-Broadcom design uses a BCM4704 processor, 16 MB of RAM and 4 MB of flash. The 10/100 WAN and LAN ports are handled via a BCM5325 switch which is Auto MDI/X.

A BCM4321 Baseband/MAC and BCM2055 2.4/5 GHz Intensi-fi draft 11n transceiver make up the dual-band 11n radio. The second radio is provided by a BCM4318 single chip 802.11b/g chip. Each radio has its own printed-circuit "metamaterial" antennas; three for the draft 802.11n radio and two for the 802.11b/g.

WNDR3300 board
Click to enlarge image

Figure 1: WNDR3300 board

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

SO i have two routers the main one I use for my internet which is RT-AC53 and I ordered Another router (RT N12) to extend my wifi/internet 50 Meters a...
I'm setting up a network at another house and would like to have that LAN and my home LAN permanently connected via OpenVPN. Both LANs are AC86U-based...
Hi Guy's,Just got a new AC86U and setup a VPN connection with Newshosting, However on my Xbox1 it now shows that I have a DoubleNAT.Can anyone assist ...
Read the list of 100 worst passwords of 2018.Source: https://www.purevpn.com/blog/worst-password-list/Does any password relate to you in the past? Wha...
Browsing the internet when all the sudden there was a crash. I'm not a very good troubleshooter, but it appears it was the RT-AC88U router (384.9 firm...

Don't Miss These

  • 1
  • 2
  • 3