Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

The WRT310N is Cisco's top-of-the-Linksys-line single-band draft 802.11n router. The Broadcom-based design includes a BCM4785 SoC with 32 MB of RAM and 4 MB of flash.

The 2.4 GHz radio uses a BCM4321 BB/MAC and BCM2055 2x2 dual-band radio, locked down to 2.4 GHz operation. The Gigabit Ethernet WAN port and four switched LAN ports are provided via a Broadcom BCM5397 5 port switch, which does not support jumbo frames.

The standard feature set found in other Linksys wireless routers are also supported in the WRT310N and include simple upstream priority-based QoS, access restrictions and dynamic DNS clients for TZO and DynDNS. The 310N, however, does not include a USB port to support sharing an attached USB drive.

WEP, WPA and WPA2 (both "Personal" and "Enterprise") wireless security is supported, as is Wi-Fi Protected Setup (WPS). Wireless throughput, however, is reduced to 802.11g speeds (~ 22 Mbps, best case) when either WEP or WPA/TKIP security is used. There is no significant speed reduction when WPA2/AES security is used.

Routing throughput measured 136.3 Mbps WAN to LAN and 156.2 Mbps LAN to WAN with the SPI function enabled. Maximum simultaneous sessions topped out at 160.

Best-case (Location A) maximum wireless throughput in the default 20 MHz bandwidth mode measured 69.7 Mbps running downlink and 59 Mbps uplink averaged over a 1 minute test. Switching to 40 MHz mode improved throughput to 77.1 and 83.8 Mbps for down and uplink, respectively.

A full review is coming soon. In the meantime use the Router and Wireless Charts to compare the WRT310N against other products.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi there,I'm using R7800 and AC86U for around 4 years, and thinking about changing them, the R7800 starts to lost signals.I checked the front-page and...
Update 2020/12/31 (9.0.0.4.386.41535) 386 rc2-10 - Google Drive drive.google.com This version includesZenWiFi XT8, XD4, CT8GT series: GT-AX1...
Small rented townhouse apartment around 800 sq ft. Hard wire means loose cords. Two floors with a center stairway. Currently running Spectrum 400Mbps ...
Just got the AX86U. Logged in offline, and uploaded the newest firmware I had already downloaded from the site, and finished setting it up. Once I did...
I have an ADSL modem coming into a very small panel near the entrance to my home. The panel is big enough to house a 68U or maybe 86U. Inside the pane...

Don't Miss These

  • 1
  • 2
  • 3