Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

NETGEAR WN2000RPT Universal WiFi Range Extender

At a Glance
Product NETGEAR Universal WiFi Range Extender (WN2000RPT)
Summary Easy-to-use dual-stream 802.11n wireless repeater / bridge with built-in four-port switch
Pros • Supports 300 Mbps maximum link rate
• Good setup wizard
• Can be used as repeater or bridge
• Doesn't require WDS
Cons • 2.4 GHz only
• Can't be used as access point
• Might not help much

Many products designed to stretch your wireless network's range have passed across the SNB test bench. Most don't deliver anywhere near what they promise, or require a router supporting WDS, or are near impossible to set up, or all the above.

So I cast a skeptical eye upon NETGEAR's WN2000RPT (not to be confused with its WNR2000 Wireless-N Router) as I unboxed it and prepared to be unimpressed. Little did I know that I'd be pleasantly surprised instead.

Inside

Figure 1 shows the inside of the WN2000RPT. Most of the good stuff is covered by RF shielding and heatsinks. But the FCC ID photos include a detail showing an Atheros AR9103 2.4 GHz 3X3 MIMO 802.11n radio, which is typically paired with an Atheros AR9132 3X3 Wireless Network Processor.

WN2000PT board

Figure 1: WN2000PT board

Note that this is a full dual-stream N extender, not single stream like the Innoband HomePlug AV Wireless N Kit. So you have more bandwidth to work with (or throw away due to repeating).

The design includes a four-port 10/100 switch, which I think is supported via an Atheros AR8236. So the WN2000RPT can also be used as a wireless bridge to wired clients, which will not suffer the 50% throughput reduction that wireless clients associated with it receive. 32 MB of RAM and 4 MB of flash finish up the design.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

So basically. When it came. Its still fine . I just connect it to the internet. Let it update the firmware. Then reset . Then I go set the router for ...
Hi Folks,This seems like the best place to ask. I upgraded from an R7000 (original AC1900 version) Nighthawk to the XR500. I wanted the R7800 hardware...
I tried to update my AC87U to 384.12 firmware and the router just doesn't survive from the update and settings process. I'm using the router in AP mod...
I am unsure which forum category this belongs in, so I am just putting it here in OTHER.I have an ASUS AC3100 and AT&T ZTE cellular modem. I am trying...
helloiam Portuguese, so my English is a little bad.i haver Merlin firmware, Router Asus rt ac86u, can I put 2 vlans on same port? example I need vlan ...

Don't Miss These

  • 1
  • 2
  • 3