MU vs. SU
In Is MU-MIMO Ready For Prime Time?, I used composite MU and SU plots to compare MU to SU throughput as the number of MU STAs increased. For the Router Charts, this is simplified with the MU, SU Throughput Difference plot. The average view shown below lets you quickly zero in on the better performing products.
MU, SU Throughput difference - average
You can then compare up to four products to see how MU throughput gain varies with the number of MU STAs. The results are very different for our three example products. Only the NETGEAR R7800 has the expected performance. It even does a great job of maintaining total throughput gain as the number of MU STAs increases.
Most products behave more like the TP-LINK and fall to near zero throughput gain by the time our 16 STA test limit is reached. The Linksys EA7500's plot is misleading; throughput for 8 and 14 STAs is only as high as shown because there are no SU results for those tests.
MU, SU Throughput difference vs. STA
We'll now look at the MU, SU Difference results for each product. The NETGEAR R7800 is the best example of what you should expect from a MU-MIMO router. Total throughput gain peaks at three devices, then remains as close to that peak as possible as more MU devices are added. Some throughput decline is expected, but the slope should be as gentle as possible.
MU, SU Throughput difference vs. STA - NETGEAR R7800
The NETGEAR R7500v2 would be our next pick for a well-behaved MU-MIMO router. Its curve is nowhere as good as the R7800's. But the router does a decent job of keeping throughput gain high out to 11 MU STAs.
MU, SU Throughput difference vs. STA - NETGEAR R7500v2
The Linksys EA8500 begins the transition into products with less desirable MU-MIMO behavior. Its throughput doesn't peak until six STAs, but at least it's a decent gain when it does. Throughput decline is fairly steep, but there is still 100 Mbps gain over SU with 14 STAs.
MU, SU Throughput difference vs. STA - Linksys EA8500
TRENDnet's TEW-827DRU starts out well, but only produces 250 Mbps of additional throughput when it properly peaks with three devices. From there, decline is swift with many point of net throughput loss after 9 STAs.
MU, SU Throughput difference vs. STA - TRENDnet TEW-827DRU
TP-LINK's Archer C2600 is another router you should let someone else buy if you have a lot of MU-MIMO devices. Like the Linksys EA8500, it produces peak throughput gain with six STAs, then quickly loses the gain as more STAs are added. The more troubling behavior is the net throughput loss with up to three STAs in use.
MU, SU Throughput difference vs. STA - TP-LINK Archer C2600
QCA and Linksys have some work to do to improve the 3x3 Linksys EA7500's MU behavior. As noted previously, behavior seems to fall apart after six MU devices are connected. And MU throughput gain is not very impressive up to that point.
MU, SU Throughput difference vs. STA - Linksys EA7500
Curiousity got the better of me and I decided to see if Broadcom's beta MU-MIMO firmware produced anywhere near reasonable performance. It didn't. I loaded up an ASUS RT-AC88U with 22.214.171.124.380_2697 beta firmware and ran the MU-MIMO test suite. The plot below shows both test runs and the average of both MU and SU results.
MU vs. SU - ASUS RT-AC88U
Broadcom MU-MIMO is clearly not ready for use judging by these results. Not only is there a fairly rapid decline as SU STAs are added, there is modest MU throughput gain only in one of the two MU test runs. There may be other reasons to load up this beta release, but MU-MIMO performance isn't one of them.
It looks like 2x2 MU radios are going to be common in high-end smartphones. So I ran the MU-MIMO test suite and simply switched the Veriwave to use 2x2 SU and MU STAs instead of 1x1. The results of two test runs on a QCA-based NETGEAR R7500v2 are not encouraging.
The 2x2 STAs yield 250 Mbps higher MU and SU starting throughput than 1x1 STAs. But there is again only one MU test with net throughput gain over SU. All the other tests produced lower MU throughput than SU. The only good news here is SU throughput is pretty well-behaved as STAs are added.
MU vs. SU - ASUS RT-AC88U
Even though we're in the second generation of MU-MIMO routers, the technology still has much maturing to do. Folks who have been developing MU-MIMO in mobile technologies know this is hellishly complex stuff; far beyond my simple mind's ability to grasp much beyond its basic principles.
I have to say I'm not a believer that MU-MIMO will end up as a significant contributor to improving the lot of folks trying to tame the Wi-Fi beast. But for consumer router makers, it's one more thing to slap on the box front in hope of luring desparate buyers.
Just like the non-MU beamforming that is part of 802.11ac, MU-MIMO will probably contribute something to better Wi-Fi performance down the road. But it will be years before it's a significant contributor. 802.11ax will be here by then, giving Wi-Fi marketeers more buzzwords to use and driving poor Wi-Fi consumers even further into madness.
That said, if you simply must have a MU-MIMO router now, your best best for sure is one based on QCA's MU-MIMO technology. And of those, NETGEAR's R7800 Nighthawk X4S looks like it deserves its #1 spot in our AC2600 Router Ranking for MU-MIMO performance, too.